Univex SRM60 Specifications download pdf (Page 18)

SRM6O+/SRM8O+

Speed control assembly towards the front ofthe machine (shifting to 2nd

second speed will help).

Note: The assembly must remain perpendicular to the mixer housing walls.

Failure to do so will result in the binding ofthe shaft (Fig. 8 [10]) in the

bearing (Fig. S [21}). Retighten the Kep nuts and run mixer in ist speed and

check belt position. Repeat procedure if necessary.

Once the upper pulley (Fig. i i [5}) has been adjusted, the lower pulley

must

be checked. Start mixer and shift to 4th speed. Turn mixer off and

check

position ofbelt. The belt should be flush to 1/16" below outer edges of the

pulley flanges. Ifadjustment is needed, loosen Kep nuts (Fig. li [14])

and

raise or lower the motor using the Kep nuts on the under side of

motor.

Retighten top Kep nuts and run mixer in 4th speed to check

new belt position.

Note: The motor must remain level with the mixer base (Fig. 10

[1]).

If not,

poor shifting and belt life will result.

WARNING: FOR SAFETY, DISCONNECT ELECTRICAL POWER.

DRIVE BELT SETUP

TO I/IS MAX.

MOTOR

Check motor (Fig. 11 [16)) for overheating and excessive noise.

Ifdefective, send

to a local electrical repair shop.

BOWL LIFT ADJUSTMENT

WARNING: FOR SAFETY, DISCONNECT ELECTRICAL POWER.

Check adjustment by placing the bowl on the lowered bowl

support, and place

a batter beater on the beater shaft (Fig. i [11).

Raise bowl support to the upper position,

Check clearance between bottom of the bowl and the adjacent underside of

the

batter beater. Clearance should be 3/16" ± 1116".

Page 17

SPEED

CONTROL

HÑ'DLE

HANDLE

ON SPEED 4

ON SPEED

O TO VIE MAX.

PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 42 43

Comments to this Manuals

No comments

Univex SRM60 Specifications Page 18

Comments to this Manuals

Related products and manuals for Mixers Univex SRM60