Univex MG22 Instruction Manual download pdf (Page 4)

Installation;

This is a table-top unit. Unit may be secured to table top via the shipping bolt threaded holes

on the

power drive housing bottom.

Insure the unit is located such that it is placed on a level and stable surfàce, and sufficient clearance

is provided all around the unit for safrty and ease of operation. Proper location includes space for

the feed pan and clip-on storage container,

Feed pan support bracket (Item 45) must be assembled onto the housing cover (Item 43) using the

screws (Item 46) provided.

ASSEMBLY AND OPERATING INSTRUCTIONS;

Introduction:

The Univex MG22 Meat Grinder consists of a I H.P. electric motor power base which drives a

bell-shaped meat grinder designed to utilize industry standard #22 knives and full range of #22 grinding

plates. Included as standard equipment is a carbon steel knife (Item 3), 3/16 grinding plate (Item 2),

aluminum meat stomper (Item 10), 16 x 24 aluminum feed pan (Item 9) for holding meat to be

processed, and t8.5 x 13.5 storage container with lid för collecting meat as it is processed.

The Univex MG22 has safety and ease of operation built into it. The permanent safety guard positioned

over the bell-shaped feed hopper prevents accidental entry of operator's fingers and hands into the

grinding zone, The readily removable feed pan and storage container provide for ease of processing and

cleaning.

Noise emissions below 70 db(A).

Assembly:

WARNING: Disconnect power supply prior to assembly.

Mount the housing-guard assembly (Item 8) to the housing weldment (Item 26) by firmly

tightening knobs (Item 12) onto mounting studs (Item 14).

Slide the worm assembly (Items 6,5,4) into the housing-guard assembly (Item 8) and mating into

the drive coupling (Item 15).

Slide the knife (Item 3), sharp edges toward the plate, onto the square of the worm assembly (Item

4). Slide the plate (Item 2) onto the worm assembly (Item 4). Screw the ring (Item 1) onto the

housing-guard assembly (Item 8) until it is just snug. Too much pressure can damage the unit.

WARNING: The knife is sharp and can cut fingers.

Guide the feed pan (Item 9) over the guard portion of the housing-guard assembly (Item 8) onto

the pan stud (Item 7) and the pan support (Item 44).

S. Locate the storage container under the clip (Item 24) and resting on the front legs (Item 23).

6. Connect power supply and actuate power switch (Item 25).

WARNING: Never put fingers or utensils in the throat of the grinder or the knife and

plate interface.

MG22

Page 2

PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor

1 2 3 4 5 6 7 8 9 10

No comments

Univex MG22 Instruction Manual Page 4